Auto Green / Standby Problem: Skyworth 43STC3210 and 43STC3200 Software Installation
If you encountered the defect or symptoms as show above with Skyworth 43STC3210 and 43STC3200, then you need to install a fresh operating system, burn new keys and MAC address to your TV.
Defect symptoms are as follows, when the TV plugin to the power source, it's light indicator turns red then green for a while then going back into red. Please refer to the above video for your reference.
In order for you to install the fresh software of Skyworth 43STC3210 and 43STC3200 you will need the following;
Skyworth 43STC3210 and 43STC3200:
Please refer to the video below for step by step software update guide / instructions:
2. Extract the "Skyworth 43STC3210 or 43STC3210 Software.zip" . It contains the following;
- allupgrade_3563i_sos.bin
- hdcp_cvt_3563i
- mac_cvt_3563i
2. Move the following extracted software to USB Flash drive root directory.
- allupgrade_3563i_sos.bin
3. Insert the USB Flash Drive containing the software into TV USB Port.
4. Cut the power / unplug the TV from power source for at-least 10 seconds.
5. Restore the power / plug the TV from power source. (Please don't do anything.)
6. Wait for at least 5 minutes, if the light indicator blinking it means the installation progresses.
7. After 5 minutes, the light indicator still blinking, Cut the power / unplug the TV from power source for at-least 10 seconds.
8. Remove or take out the USB flash drive.
9. Restore the power / plug the TV from power source. (If the update is successful, it will automatically boot up.)
10. Setup the TV.
11. Move the extracted file to USB Flash Drive. Please refer to below image;
***Note: USB Flash should be fat32 and no other file inside. Only "hdcp_cvt_3563i and mac_cvt_3563i" please refer to above image.
12.3 Cut the power / unplug the TV from power source for at-least 10 seconds.
12.4 Insert the USB flash drive containing folder of hdcp_cvt_3563i and mac_cvt_3563i into your Skyworth 43STC3210 / 43STC3200 USB port.
12.5 Restore the power / plug-in the TV back to the power source.
12.6 Turn "On the TV" and do nothing and wait for the pop-up message.
hdcp_cvt_3563i: OK
mac_cvt_3563i: OK
I liked your work and the way in which you have shared this article here. It is a beneficial and helpful article for us. Thanks for sharing an article like this.
ReplyDeleteShare some about tag and test Melbourne.
Working! Thanks. 43STC3210
ReplyDeleteHow? same model with you, i tried the instruction but the light indicator stuck on blinking 😭
Deletecan i repeat the process? the blinking is non stop
ReplyDelete